Hi Mitch. Thanks for the response. The Heil is plugged into the front AUX/MIC jack. The headset first goes through the adapter changing the 1/8” plug to plug compatible with the front of the K3S. That plug then goes into a second adapter that converts it into the RJ45 plug that connects to the AUX/MIC jack.
From what I can gather, then iC element is a condenser type that must be powered. I’m guessing the K3S supplies that voltage since it works locally. The RemoteRig manual says the following: "Control-RRC only: JMP-1 is placed behind the TTL connector. With the strap in place a DC voltage is feed to the microphone element. All ICOM microphones should be DC-feed. Dynamic microphones like the ones used by Kenwood should not be DC-feed. HEIL microphones should not be DC-feed either." It kind of contradicts since it states that Hiel mics should not be DC fed, but maybe that was for the older HC4/5 elements. Anyway, all of the pieces were purchase from Elecraft, so I would assume they would all work together. :-) Jim > On Dec 26, 2016, at 6:35 PM, Mitch Wolfson, DJØQN / K7DX <[email protected]> > wrote: > > Jim, > > Is the Heil plugged into the rear, or the front? If in the rea, then you must > first unplug the RRC to prevent a remote connect, then switch the audio to > the rear jack. If you leave the RRC's connected, you will only change the > remote K3 and not the control K3. > > 73, > Mitch DJ0QN / K7DX > > Mitch Wolfson DJØQN / K7DX > 10285 Boca Cir, Naples, FL 34109 > Skype: mitchwo > USA: Home:+1-239-221-9600 - Mobile:+1-424-288-9171 > Germany: Home:+49 89 32152700 - Mobile:+49 172 8374436 > > On 26.12.2016 20:27, Jim Larson wrote: >> I have a K3S connected to a remote K3 using the RemoteRig boxes. With the >> MH2 hand mic everything works great, but with my new Heil ProSet with the iC >> element (purchased from Elecraft), I do not get any transmit audio at all. >> Running the ProSet into the local K3S (no RemoteRig), I am getting audio >> out, so I know the headset is fine. >> >> Is there a configuration change that needs to be made on the RemoteRig to >> work with this ProSet iC element? >> >> Thanks, Jim - KK7A >> >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
