Hi Don, Thanks, I built the K2 and have not yet installed any plugs. I plan to install 3 at pins 1,2 and 7.
73, Ken WZ6P On Tue, Jan 3, 2017 at 12:06 PM, Don Wilhelm <[email protected]> wrote: > Ken, > > That will work OK -- BUT only if your K2 microphone configuration header > is wired for either the Elecraft (without the bias resistor) or the Kenwood > mic pinout. > > If you built the K2, you should know how it is plugged, but if you bought > it used, check it. > > If the bias resistor is installed, lift the resistor lead off mic jack pin > 1. > > 73, > Don W3FPR > > > On 1/3/2017 2:57 PM, ken mcmahon wrote: > >> Hi everybody, >> >> Here is my plan, please check me: >> >> Using a hybrid cable that I made for my K3 9 years ago.... >> >> 5 pin Kenwood 'B Connector' (per the MC-50 manual) to an 8 pin DIN >> connector (K2 connection). >> >> 1 - 1 AF >> 2 - 2 PTT >> 5 - 7 GND >> >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
