Ken,
Install an additional one at pin 8.
That will allow you to use any Kenwood dynamic mic.
73,
Don W3FPR
On 1/3/2017 5:18 PM, ken mcmahon wrote:
Hi Don,
Thanks, I built the K2 and have not yet installed any plugs.
I plan to install 3 at pins 1,2 and 7.
73,
Ken WZ6P
On Tue, Jan 3, 2017 at 12:06 PM, Don Wilhelm <[email protected]
<mailto:[email protected]>> wrote:
Ken,
That will work OK -- BUT only if your K2 microphone configuration
header is wired for either the Elecraft (without the bias
resistor) or the Kenwood mic pinout.
If you built the K2, you should know how it is plugged, but if you
bought it used, check it.
If the bias resistor is installed, lift the resistor lead off mic
jack pin 1.
73,
Don W3FPR
On 1/3/2017 2:57 PM, ken mcmahon wrote:
Hi everybody,
Here is my plan, please check me:
Using a hybrid cable that I made for my K3 9 years ago....
5 pin Kenwood 'B Connector' (per the MC-50 manual) to an 8 pin DIN
connector (K2 connection).
1 - 1 AF
2 - 2 PTT
5 - 7 GND
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
