No, no, Ken. That was just the subject line of the email thread. The ORIGINAL problem occurred when turning the AGC OFF, the AGC voltage to the S meter and IF amp went high causing the IF amp to shut down. In the K2, the S meter is a visual representation of the level of the AGC voltage being sent back to the IF amplifier in the presence of strong signals. The stronger the signal, the higher the voltage sent back to control the gain of the IF amp. The S-meter gets set with the AGC turned ON.
If you have set your AGC threshold level, S meter Lo, and S meter High settings per the instructions and are happy with the action you see, then you probably don't have a problem to solve. 73, Ken K3IU -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ken K3IU Sent: Sunday, March 26, 2006 12:58 PM To: 'Nick Waterman' Cc: [email protected] Subject: RE: [Elecraft] AGC off problem solved I was perhaps the first one to encounter this "AGC Off" problem and ultimately changed X1 to solve the problem. Nosey's comment below re the improved S-meter action caused me to try something. I am currently realigning and tweaking K2 5044 that I built last August and remembered that there had been (and still is) a lot of "weirdness" in the S meter action. Very difficult to get it set correctly; anyway, I decided to replace Ctrl-C8 with a 10 pf cap to see what difference it made. Well, it made all the difference in the world. Now very easy to set the AGC threshold level, S meter Low, and S meter High. I checked it with the 50 mV from XG-1 and it is about S9 + a wee bit with Pre and Att OFF. It reacts sanely and appropriately. Nice! 73, Ken K3IU -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Nick Waterman Sent: Sunday, March 26, 2006 11:54 AM To: [EMAIL PROTECTED] Cc: [email protected]; [EMAIL PROTECTED]; [EMAIL PROTECTED] Subject: Re: [Elecraft] AGC off problem solved Dr. Werner Furlan wrote: > I can report a success with my problem I reported yesterday. > I changed C8 to 10 pF and now AGC off works as expected. Yay! Me too! Much easier than sending off to Elecraft for a new X1. When I tune the RWM pips with fast AGC, it properly goes "pip sssSSSHH pip sssSSSHH pip sssSSSHH", and more importantly, when I turn the AGC OFF, the rig doesn't go deaf. The S-Meter looks a whole lot more believable too, the rig feels a whole lot more sensitive, and now I can turn AGC off, I can confirm that my N-GEN really does work after all! _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
