Those resistance values should be fine. I asked a similar question when I
was building my K2, and got that answer.
Question: I'm measuring resistances on Control Board,
ala page 21 table. On a few measurements, I'm getting
MUCH higher resistances than table indicates:
U6 pin 13 supposed to be > 100k got INFINITE
U6 pin 14 supposed to be > 100k got INFINITE
U6 pin 29 & 30 to be > 70k got 85k
U8 pin 2 to be > 100k got 6.6meg
U8 pin 15 & 16 to be > 100k got INFINITE
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
