The VX; command (GET only) will return the current state (VOX ON or OFF = PTT).
*Note:* there is an error in the documentation in the K3 Programmer's Reference <http://www.elecraft.com/manual/K3S&K3&KX3&KX2%20Pgmrs%20Ref,%20F8.pdf>, which says: "RSP format: VXn; where n is 0 (VOX on) or 1 (VOX off)." (sic) But the observed responses are quite the opposite, and far more intuitive: VX0; VOX is OFF VX1; VOX is ON The current Programmer's Reference still says "A SET version of the command is planned." But I suppose those plans are not very high on the priority list. 73, Bob, N6TV On Sat, Mar 11, 2017 at 8:29 AM, K5MWR via Elecraft < [email protected]> wrote: > At one point in the macro command reference there was a statement that > VOX/PTT selection would be available through a direct macro command. > Currently all I am able to make work is the SWT or SWH type command which > is basically of no use since there is no way to know what the current mode > is. Has anyone found a work-around for this? > Thanks > Dave K5MWR > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
