You do have the passing under the span wide brace, don't you? And not clamped to it by the top cover.
Sent from my iPhone ...nr4c. bill > On Mar 11, 2017, at 9:35 AM, Chuck Chandler <[email protected]> wrote: > > Well, this morning I got a chance to put the K3S on the bench. Thanks to > some info from Lyle KK7P and Bob N6TV as to how things were wired up I was > prepared to trace this and that... O'scope was ready... > > Turned out to be a loose wire where the internal speaker lead connects to > the speaker lugs. I was all wrapped around the axle on CONFIG settings and > worried that a multi-pin connector might not have been seated properly... > turned out to be a simple problem. The solder lug on the speaker itself > looks to be well soldered, but there is what looks like a crimp in that > conductor just a bit upstream. My bet is there is a break in the wire > inside the insulator there. > > For now, some electrical tape is holding the wire tight against the speaker > so it can't move around. I'll email support and request a replacement. > Thanks for the info, fellows! > > 73 de Chuck, WS1L > > -- > > > =================== > Chuck Chandler > [email protected] > =================== > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
