2/ BYPASS MODE
The bypass mode can be set to DSP BYP using the menu.
However, this does not actually bypass the KDSP2.
Please note the current the K2 is drawing (use the DISP button) when in
operating mode and in bypass mode. If the current drain is reduced, the
KDSP2 is bypassed and the effect is from something else, perhaps the
current crystal filter setting.
In bypass mode, the DSP goes into a low power mode and the CODEC is
mostly turned off, just leaving the analog section operating to pass the
signal through.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
