Bob,
You can get the new encoder from Elecraft - it is p/n K2ENCASY.
It contains the new encoder, a new knob and several other components as
well as the encoder board.
If this is your only option, be aware that the spacing between the new
encoder board and the back of the Control Board is critical.
You must flush trim the leads on the Control Board where it can contact
the encoder board and also flush trim the encoder board after it is
assembled. Flush trimming means really flush - diagonal cutters are not
sufficient.
You will also have to enlarge the hole for the encoder in the Front
Panel metalwork a bit. A knife run around the hole a couple times will
allow the encoder shaft adequate clearance.
You might want to put a piece of "fish paper" between the encoder board
and the Control Board.
73,
Don W3FPR
On 3/22/2017 5:59 PM, Bob G3PJT wrote:
Hi
I need a main tuning encoder of a K2. The Elecraft part number is
E640003 and on the back the makers number is EC202C025A-2TD
If you have one spare please mail me off list
73 and thanks
Bob G3PJT
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
