Tom,
I'm not sure which Winlink software you are running, but it should
work. Check to see that you have VOX on so that when you start to send
tone the radio goes into transmit. If that is OK, you may need to tell
your software to use software control for PTT.
73,
K3NDM
Barry
------ Original Message ------
From: "Tom S Bingham" <[email protected]>
To: [email protected]
Sent: 3/28/2017 9:25:09 PM
Subject: [Elecraft] K3S and Winlink
I have installed the Winlink software but I cannot place my K3S into
transmit when using the Winmor protocol. The channel selection feature
changes frequencies on the rig properly. And, when I place the K3S
into transmit manually, the modem tones cause ALC to register.
As a side note, Fldigi works fine. Both Winlink and Fldigi are set to
the same COMM port and the K3S is in USB mode with under CONFIG:RS232.
Fldigi is not running when I use the Winlink software. I use the
Elecraft supplied KUSB cable between the computer and the K3S.
Can anyone give me a clue?
Thanks!
Tom
-- Tom Bingham WB7EUX
http://www.wb7eux.net/
SKCC 9833S
NAQCC 6346
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
