Hi,
does anybody have any advice for writing a macro that will allow VFOb to
be controlled with the main VFOa tuning dial when operating in split mode.
It gets a bit annoying having to continually tune with the small OFS/B knob,
and whilst swapping frequencies from A to B works, that too can be a
nuisance in certain situations. I have the programmers reference guide and
have been looking through it, but I do not recognise then commands that
allow you to reassign control of specific parameters (in this case the VFOb
TX frequency) to different buttons or encoders (in this case the main VFOa
rotary encoder). Any help or advice would be greatly appreciated.
73 de OE6FEG / M0FEU
Matt
--
View this message in context:
http://elecraft.365791.n2.nabble.com/KX3-macro-for-swapping-VFOb-control-when-working-split-tp7629176.html
Sent from the Elecraft mailing list archive at Nabble.com.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
