Real PA designs are very far from correctly reverse terminating the
transmission line. The maximum power transfer theorem is a complete red
herring in this sort of situation. For example, on the top of page 12
of the third edition of the Art of Electronics, immediately after
setting the maximum transfer theorem as an exercise, they point out that
ordinary output stages are operated far from that condition.
The only case in which you might get reverse termination, is if there
was a (typically ferrite) isolator. In that case, the PA wouldn't care
about the mismatch (at least not for an ideal isolator), but the
terminating resistor in the isolator might glow red or white if you
shorted or opened the output. In practice they are normally microwave
devices, but I suppose they may be used in professional HF systems.
In real systems, most of the reflected power bounces straight back out
again when it hits the PA, to get another chance to be lost in the
feeder, or even radiated. Of course this may cause the PA to run out of
volts, or gain, and clip or distort, or exceed the safe operating area,
and melt bond wires, or destroy the chip itself.
--
David Woolley Owner K2 06123
On 22/04/17 05:47, John Perlick wrote:
Well, it might incrementally improve the loss in the coax because the reflected
wave from a high SWR antenna would not be the-reflected at the amp. It would
be fully absorbed into the amp which is well matched.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
