Wondering if he has a XVERTER inabled. Sent from my iPhone ...nr4c. bill
> On Apr 29, 2017, at 4:26 PM, Matt Zilmer <mzil...@roadrunner.com> wrote: > > This is very confusing, Stan. Are you saying that if you tap BAND (up), you > move from 24 to 28.676 MHz and then can't dial VFO A down to 28.4? > > Explanation of why this is confusing / strange / whatever: VFO A is just an > optical encoder with A/B outputs. A and B act in quadrature (only one of > them changes per "click") and the transitions are counted by a > microcontroller (MCU). The only limit on what frequency range you can dial > to is the firmware inthe MCU. The K3 allows receive from VLF (136 KHz) > through 30 MHz, used without a transverter. > > Why don't you try direct frequency entry before any next steps. See if you > can enter 28.400 MHz. At least that will put you on freq. Then you can > memorize it using the V > M switch. > > I wouldn't EE INIT the radio until all other options are exhausted. If you > decide to do that anyway, be sure and save your K3's configuration first. > You'll need to restore it after the "set defaults" is completed. > > 73, > > matt W6NIA > > >> On 4/29/2017 11:03 AM, KG7FYI wrote: >> Thanks Matt. Nope all bands are set to In. I am unable to dial 28.400. >> The band jumps from 24.842 to 28.676. Perhaps I should try dropping >> everything down to default settings and see what happens? >> >> 73 >> Stan KG7FYI >> >> >>> On 04/27/2017 10:44 AM, Matt Zilmer-3 [via Elecraft] wrote: >>> BND MAP may be set to OFF for 10m on his K3. See p54 of the Owner's >>> Manual. >>> >>> 73, >>> >>> matt W6NIA >>> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
