I bought two factory K3S's, to save money one came without the sub-receiver. I later realized that this was a mistake and added the KRX3A. Installing it is a time consuming job and does involve removing the front panel. I am not sure what your concern is, the front panel was easy to reinstall and everything worked as it should after adding the module.
John KK9A From: Irwin Darack idarack at gmail.com Fri May 12 08:34:57 EDT 2017 different frequency on the same band) on my K3s, I need to install the KRX3A sub-receiver. I have two K3s that I have built, one with the KRX3A and the second without. I am thinking of upgrading the second one with the sub-receiver now. To install a KRX3A in an already built K3s do I need to remove the front panel? I am hoping that I do not as to reinstall the front panel you have to be very careful not to bend a pin. I realize that I have to install some new additional stand-offs on the main RF board. I have reviewed the KRX3A install instructions and it's a little confusing on the difference in a older K3 versus a K3s. It appears that you have to take the front panel totally apart? Looking forward to see everyone at Dayton (Xenia). Thanks, Irwin KD3TB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
