I changed the VFO frequency range capacitor to 120 pf and now have a 178 khz tuning range. Since I only need 125 khz to reach the SKCC frequency of 7120 khz, I may try a 100 pf capacitor. I would like to know what types of capacitors will work will here. The 68 pf capacitor is a disc ceramic and the 120 pf capacitor is a polystyrene type. To make this change, I not only needed to change the VFO capacitor, but also the 30m xtal and futz around with the turn spacing on the VFO coil to get the proper VFO range. I do not find the 18 khz per revolution tuning rate to be difficult but it is my nature to keep fussing. 73 - Rick - K7MW ----- Original Message ----- From: "Rick Dettinger" <[EMAIL PROTECTED]> To: <elecraft@mailman.qth.net> Sent: Monday, April 03, 2006 10:12 PM Subject: [Elecraft] K1 AGC time constant
> I changed C31 on the RF board to 1uf but it still seems very slow. When I > remove an S9 siginal (50uv) it takes about 15 seconds for the S meter to > decay to one bar. I used a non polorized electrolitic cap as that is what > they had at RS. It is physically larger than the original cap but there is > plenty of room. I am not sure what a non polorized electrolitic capacitor > is but there are no polarity marks, which I haven't seen before. Should I > try a smaller value for C31? Thanks - Rick - K7MW > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com