Thanks for the help--Bandwidth was showing full on the screen on the K3s, but when I hit the XFIL a couple of times it cleared up even though I did not change any filters. It stayed ok for a couple of hours of making contacts, so I hope it is cured... 73 Jim W6US
On Fri, Oct 6, 2017 at 3:52 PM, Don Wilhelm <donw...@embarqmail.com> wrote: > Jim, > > Yes, the filter width in DATA A mode defaults to a narrow bandwidth - even > though you have the 2.8kHz filter, it still defaults to a narrow bandwidth > like 400 or 600 Hz (I can't recall which). > That is an aid to those who choose to use the VFO dial to tune in a single > data mode station. > > SSB mode defaults to the 2.8kHz. > > Not to worry, it is easy to change, just grab the WIDTH knob and turn it > until you see a waterfall width to your liking. > > 73, > Don W3FPR > > On 10/6/2017 6:28 PM, Jim Shepherd wrote: > >> When I switch to DATA mode, the receive bandwidth is only about 600 Hz >> even >> though when I check with Data MD it shows the USB mode. I have the 2.8 >> filter selected and it shows on the display and using the K3 Utility >> program. >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com