Although you may use a different combination of ACC signals than me, FWIW I routinely parallel multiple sets of accessories off my ACC connector. When I'm operating remotely, I have two band decoders, a RemoteRig box, and a KPA500 connected. No switch, no problem.
If you're using circuits I'm not and have a problem, note that many VGA switches don't switch all 15 lines. 73, /Rick N6XI Rick Tavan Truckee, CA On Tue, Oct 10, 2017 at 2:16 PM, Dan AE9K <[email protected]> wrote: > In preparation for the arrival of my KPA1500 I was wondering if a simple > two-port VGA switch would be the best approach for switching the ACC/AUX > line to allow the selection of the KPA500 or the KPA1500. Or is a simple Y > cable ok? Pin 10 PTT would be open ahead of the switch or Y cable to allow > continued use of the keying line which is switched among two amps currently > - soon to be a third. > > I assume at some point the KPA1500 will just become the only amp connected > but in the short term a lot of A/B testing will occur so I'm just looking > for the simplest means of accommodating both the KPA500 and KPA1500 without > moving the ACC cable back and forth. > > 73, > > Dan > AE9K > > > > -- > Sent from: http://elecraft.365791.n2.nabble.com/ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
