Tom,
Did you connect the KX3 Keyout signal into the KXPA100 PA KEY input?
That is necessary for 'Basic Operation' - see page 18 of the manual.
73,
Don W3FPR
On 10/27/2017 3:24 PM, Tom wrote:
Hi,
Just to be sure, I disconnected all control signal, only RF into the amp
at 10W....
No output, but no errors in the KXPA100 utility.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
