Robert,
The KPA500 will run OK on 110 (actually 115 or 120) volts.
The real question is how many other receptacles are on the same 120 volt
circuit. Are there any other large current drawing loads on that same
circuit, and how much wire run from the breaker box to the receptacle
being used.
Figuring an efficiency rating of 50% for the KPA500, the current draw
for the KPA500 will be 9 or 10 amps. The common receptacles are rated
for 15 amps, and it depends on whether the wire size used is #14 (usual)
or #12. The smaller wire will have more voltage drop.
Electrical code requires #12 wire for kitchen outlets in modern
buildings. But the remainder can be #14.
The other thing is that if the receptacles were wired using the
"backstab" connections, that can create a higher resistance. I would
have an electrician check all receptacles on the circuit feeding the
receptacle and change any receptacles using the 'backstab' connections
to the lower resistance wires placed under the receptacle screws.
Since I had the advantage to wire my own house, I used #12 for all
receptacles, and in the hamshack area, I have a dedicated circuit for
the two receptacles there. Most installations cannot boast of that same
advantage.
73,
Don W3FPR
On 10/29/2017 10:23 PM, Robert G Strickland wrote:
What's the conventional wisdom on running the KPA500 on 110v? At my
previous QTH I had 220v, so never had to face this issue. In my new QTH
there's no 220v -yet. The operating environment is 100% cw with
occasional contests. Thanks for all opinions in advance.
...robert
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
