Bruce, Check the end of L6 closest to the wire you added at trimmer cap CC - L6 should not connect to the trimmer pad, but it is close, so a slight solder splash will cause a short there.
73, Don W3FPR > -----Original Message----- > > L6 is good, it measures 1 ohm. But I'm seeing only 1 to 4 ohms > from min to max > RF gain. That tallies with what I'm hearing- the RF gain has > almost no effect > on received sigs. So I'll look for whatever is pulling R1 down. > > Thanks again- it always helps to have a second set of "eyes". > > 73 > Bruce > N7CEE > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
