Looks like the EEPROM may not be initializing. Double check U7 and make
sure you don't have any bad/missing solder joints and make sure it is
oriented the right direction.
I don't remember if it is in a socket or not, but if so, make sure all
the pins went into the socket. Basic stuff but the kind of mistake I
would be likely to make.
73,
Mike, KI0HA
On 11/15/2017 19:55, Dan, K7DJK via Elecraft wrote:
Need some help here.
Been working on my K2 S/N 7770 and got to the point where power is first
applied.
Upon pressing the Power button, got the INFO 201 message, but it just remained
on the display. It never went away and I never saw the ‘7100.00c’.
Turned power off and then cycled it back on. Now, the display is simply blank.
Nothing.
I reset the K2 (pressing 4-5-6 then powering up), and the INFO 201 came up
again with the same symptoms.
Would appreciate any thoughts on what might be happening.
73,
Dan, K7DJK
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
