Also check the manual section "Troubleshootin", there are specific hints for "INFO 201" error. Good luck and 73.
Iw2noy > Il 16 novembre 2017 alle 9.15 Michael Eberle <[email protected]> ha scritto: > > > Looks like the EEPROM may not be initializing. Double check U7 and make > sure you don't have any bad/missing solder joints and make sure it is > oriented the right direction. > I don't remember if it is in a socket or not, but if so, make sure all > the pins went into the socket. Basic stuff but the kind of mistake I > would be likely to make. > > 73, > Mike, KI0HA > > On 11/15/2017 19:55, Dan, K7DJK via Elecraft wrote: > > Need some help here. > > > > Been working on my K2 S/N 7770 and got to the point where power is first > > applied. > > > > Upon pressing the Power button, got the INFO 201 message, but it just > > remained on the display. It never went away and I never saw the ‘7100.00c’. > > > > Turned power off and then cycled it back on. Now, the display is simply > > blank. Nothing. > > > > I reset the K2 (pressing 4-5-6 then powering up), and the INFO 201 came up > > again with the same symptoms. > > > > Would appreciate any thoughts on what might be happening. > > > > 73, > > Dan, K7DJK > > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
