Apparently I forgot to quote the original message I was replying to. It
happens in Data mode only on 6 meters. It does it with both VFOs on the
same frequency (i.e. 50.276) or with one VFO a few kHz away, both VFOs
in Data mode. I probably would have never noticed it had it not been
for JT65 since WSJT-X always turns SPLIT on automatically and moves VFO
B around depending on where you are on the waterfall.
Mike, KI0HA
On 11/16/2017 14:58, Nr4c wrote:
What mode and frequency on VFO B AND VFO A when this occurs?
Sent from my iPhone
...nr4c. bill
On Nov 16, 2017, at 3:50 AM, Michael Eberle <[email protected]> wrote:
Was this issue ever resolved? I have noticed the same thing with mine
although the issue does not appear to be the tuner itself, but the K3 is not
transmitting any power so the tuner has nothing to work with. I am running
FW version 5.60 an have this issue but only on 6 Meters.
I can power up the K3 and open WSJT-X on my computer and select 6 meters
which usually causes SPLIT to turn on. Hold TUNE and the TX keys and the
display shows 0 power. Turn off SPLIT and it puts out power as usual. Then
if I turn SPLIT back on, it will then output a carrier as usual.
If SPLIT is enabled on 6 meters and you run a TX gain calibration, it will
fail the calibration because the TX puts out no power.
It's not a major issue but an annoyance since I tend to forget about it
every time I switch from HF to 6 and try to check my antenna tuning.
Thanks,
Mike, KI0HA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
