HiActually what is happening is that both the p3 svga and the utility are attempting to get access to the decoded text at the same time so when one gets a character, the other misses it.. If you wish to use the utility, just turn off text decoding display on the svga. 73 Tom
Sent from my Samsung Galaxy smartphone. -------- Original message --------From: MaverickNH <[email protected]> Date: 2017-11-25 2:31 PM (GMT-05:00) To: [email protected] Subject: [Elecraft] K3S/P3-SVGA CW Decode - P3 Power Cycle I have always had problems using the K3 Utility to change configurations from another mode to CW, as I could see text decode on the K3S VFO B display area after a restore to my CW configuration but not on the P3-SVGA external display without a lot of fiddling. I see now that simply turning the P3 on/off is required after a configuration restore to get that text decode to display. I would make a note of that but would just forget where I put it. Now, it's right here for me to find! Bret/N4SRN -- Sent from: http://elecraft.365791.n2.nabble.com/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
