Newly assembled working great so far. At the Owners Manual Calibration Procedures pg 52 (Fred Cady book Elecraft K3S and P3 referred me to Owners Manual for some Calibrations after going through Configuring the K3S pg 26...) Wattmeter: Both CONFIG:TUN PWR and PWR SET to NOR (KPA3A not installed yet, all covers on. Low-Power (5 W) W mtr calibration On 20 meter band at 14.050 On a 1kw Cantenna 50 ohm dummy load (ch'd w/ Ohm meter) Set power to 5.0 watts on K3S with Pwr knob Go to CONFIG WMTR LP showing Press TUNE (hear signal on Omni D) but does not register on ext W Mtr and cannot vary output with VFO A knob (which is the instructed 'Parameter' adjustment knob I assume?) Ext W Mtr is working ok with Omni D output
I must be missing something? Setting? Thanks, Tom NB5Q ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
