I could be wrong, but I thought they were low pass filters, not band
pass. I think each filter even covers more than one band if they are
within an octave or something like that.
Somebody please correct me if I'm wrong.
Dave AB7E
On 12/25/2017 11:10 AM, ab2tc wrote:
Hi all and Merry Christmas,
Well, the ham band specific HF filters are probably significantly narrower
than 2MHz, tailored to the actual width of the band in question. I don't
know if there is a way to tell the K3(S) to use a general coverage filter,
if installed, even if inside a ham band. That would circumvent the problem.
AB2TC - Knut
tomb18 wrote
HiIf you connect an sdrplay to the if output you can see over 2mhz
bandwidth. 73 Tom
<snip>
--
Sent from: http://elecraft.365791.n2.nabble.com/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
