That would suggest that using hi-cut is a better choice than RX EQ for cutting high frequency hiss. The ultimate rejection for hi-cut is greater than the max RX EQ cut, right?
Does the KX3 work the same way? I would assume so, but might as well ask. wunder K6WRU Walter Underwood CM87wj http://observer.wunderwood.org/ (my blog) > On Dec 29, 2017, at 12:36 PM, Lyle Johnson <[email protected]> wrote: > > The K3 filter is a little unusual in that the receiver equalizer is part of > the DSP bandpass filter, not a different or subsequent filter. This helps > minimize latency. > > As a result, the equalization is applied before the audio paths are > separated, so it is on all receive paths. > > In data modes, the equalizer is disabled (the filter coefficients are > re-computed ignoring the equalizer settings). > > 73, > > Lyle KK7P (author of the K3 DSP code) > > >> Prob the first 3. The 4th is mostly for digital and thus not needed. >> >>> On Dec 29, 2017, at 11:53 AM, Chris Hallinan <[email protected]> wrote: >>> >>> I understand that the K3 has two separate equalizer settings for CW and >>> SSB. I also understand it is not active in the Data modes. >>> >>> However, there are four sources of audio output: >>> >>> 1) Internal Speaker >>> 2) SPKRS (rear panel) >>> 3) Phones (front panel) >>> 4) Line Out (rear panel) >>> >>> Does the equalizer operate for all four outputs? > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
