Hi, Lyle. Thanks for helping me understand the K3 even better ;)
I'm working on building a remote solution using remotehams.com software. I hope I can use my SignaLink USB as the TX/RX audio interface to the server. I can hear very nicely on the remote (same room still!), but the transmit audio seems very low. Basically I've set MIC SEL to LineIn, and selected my SignaLink USB as the audio source for the server. I'm still experimenting with levels, etc, and that's what led to the question. Best regards, Chris K1AY On Fri, Dec 29, 2017 at 12:04 PM, Lyle Johnson <[email protected]> wrote: > Yes. > > 73, > > Lyle KK7P > > > On 12/29/17 9:53 AM, Chris Hallinan wrote: > >> I understand that the K3 has two separate equalizer settings for CW and >> SSB. I also understand it is not active in the Data modes. >> >> However, there are four sources of audio output: >> >> 1) Internal Speaker >> 2) SPKRS (rear panel) >> 3) Phones (front panel) >> 4) Line Out (rear panel) >> >> Does the equalizer operate for all four outputs? >> >> Thanks, >> >> Chris >> K1AY >> >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > -- Life is like Linux - it never stands still. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
