I tried starting 10 first then X and it didn't seem to help.Yes, the audio
config is the same in both programs.I turned off CAT but once again it didn't
help.
I asked Elecraft tech support about it but they had not heard of another case
and could offer no help.
On Saturday, January 6, 2018 12:49 PM, Josh <[email protected]> wrote:
That's really odd! It's quiet until the program starts?
What happens if you run 10 and X concurrently? Start up 10 first, it's quiet,
then start X?
Audio config on X is identical to 10?
HA!! Try turning off CAT control in WSJT-X. I bet the program is changing
something on the rig to make the noise come up.
73,
Josh W6XU
Sent from my mobile device
> On Jan 6, 2018, at 11:35 AM, Dave S via Elecraft <[email protected]>
> wrote:
>
> After I installed the KIO3B board in my K3, I found that running WSJT-X
> creates 2 or 3 S-units of noise in the rig but WSJT 10 runs quietly.Tried
> different computers, different cables, different jacks, and scads of ferrites
> on the USB cable. Nothing seems to help.Has anyone else run into this problem?
> Dave W7OJT
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
