So, you're saying everything is fine with 10 running, and as soon as you open X the S-meter goes up? If you close X with 10 still running does the S-meter go back down?
When you disabled CAT control in X, did you close the program and get back to the low noise level, then launch it again seeing the S-meter go back up? If so, with X running did you check in the settings to make sure CAT was still off? When the noise is showing on the S-meter, does unplugging the USB cable make it go away? 73 Josh W6XU Sent from my mobile device > On Jan 6, 2018, at 1:54 PM, Dave S <[email protected]> wrote: > > I tried starting 10 first then X and it didn't seem to help. > Yes, the audio config is the same in both programs. > I turned off CAT but once again it didn't help. > > I asked Elecraft tech support about it but they had not heard of another case > and could offer no help. > > > On Saturday, January 6, 2018 12:49 PM, Josh <[email protected]> wrote: > > > That's really odd! It's quiet until the program starts? > > What happens if you run 10 and X concurrently? Start up 10 first, it's quiet, > then start X? > > Audio config on X is identical to 10? > > HA!! Try turning off CAT control in WSJT-X. I bet the program is changing > something on the rig to make the noise come up. > > 73, > Josh W6XU > > Sent from my mobile device > > > On Jan 6, 2018, at 11:35 AM, Dave S via Elecraft <[email protected]> > > wrote: > > > > After I installed the KIO3B board in my K3, I found that running WSJT-X > > creates 2 or 3 S-units of noise in the rig but WSJT 10 runs quietly.Tried > > different computers, different cables, different jacks, and scads of > > ferrites on the USB cable. Nothing seems to help.Has anyone else run into > > this problem? > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
