Paul,
I have not looked to be certain, but there is a 90% probability that
they are SMD.
Contact [email protected] to obtain the part numbers. Those are not
normally Field Replacable parts.
73,
Don W3FPR
On 1/21/2018 11:02 AM, Paul Christensen wrote:
I have a K3 at a remote site about an hour north of my home so
unfortunately, I cannot quickly investigate an issue that's recently
developed. After reviewing the K3 schematics, the root cause is likely
isolated to the following parts on the PA board: D36, D37 (BAS70 - Schottky
directional coupler sampling diodes), and/or U16 (LM358 dual op-amp used as
a voltage-follower).
My question: are these three parts leaded or SMT/SMD? Perhaps I'm not
looking hard enough on the Elecraft website
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
