Fred
Welcome to the Elecraft club, membership lasts a long time!
The K2 returns to the last used frequency when you power it up, other
than that the bands just cycle round. Assuming you haven't set any
transverter bands pressing down from 1.8 MHz takes you to the 28 MHz
band, etc. Moving around the band is just a matter of rotating the
tuning knob or pressing the "rate" switch then the knob. The K2
remembers the last used frequency, mode and KAT2 settings for each band.
If there was a rotary band switch, it would create problems with
transverter bands which are hidden unless you set them in the menu.
I have a TS570, FT857, K1 and K2. I don't find navigating my way around
the K2 at all difficult.
73 Dave, G4AON
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
