You got good advice on baud rate. Also, it's wise always to confirm proper operation with K3 Utility first. If it doesn't connect, chances are N1MM won't, either. Utility marches through speeds until it finds one that works. MM requires a specific speed setting.
73, /Rick N6XI Rick Tavan Truckee, CA On Thu, Feb 15, 2018 at 5:33 PM, Greg Best <gbconsultin...@gmail.com> wrote: > I am trying to get N1MM+ to talk to my K3 but will not do it. > > I am setup for 4800 B, Data 8 bits, Parity N, stop bits 1. DTR and DTS > have > been tried with both Always ON and Always OFF but neither one works. > > I have tried the Radio reset command from N1MM+ with no luck. > > Can anyone help? > 73¹s > Greg > > 16100 Outlook Avenue > Stilwell, KS 66085 > 816-792-2913 > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to rta...@gmail.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com