It is in the latest KAT500 Serial Command Reference, and requires V1.42 or later firmware in the KAT500.
Jack, W6FB > On Mar 1, 2018, at 3:30 PM, Harlan Sherriff via Elecraft > <[email protected]> wrote: > > Thanks Dick, but I don’t see that command in either programmers reference > manual. > > So Don, there is no way to programmatically know when the tuning has > completed? > > Sent from my iPhone > >> On Mar 1, 2018, at 6:16 PM, Don Wilhelm <[email protected]> wrote: >> >> Harlan, >> >> I don't believe that is available on a real time basis (which is what you >> apparently are seeking). >> >> Yes, the K3 knows when the KAT500 has stopped tuning, but it is not >> available as a GET command. >> >> 73, >> Don W3FPR >> >>> On 3/1/2018 6:02 PM, Harlan Sherriff via Elecraft wrote: >>> Is there a GET command for either the K3 or KAT500 that will show when the >>> tuner has completed a tune? > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
