I'm building a K2 kit and I have a problem. I'm starting the Alignment
and Test, Part III on page 77-78. I have no rf out. I have followed
the rf through the tx chain and have a good signal at (RF board) Q5
collector (800mv P-P) using a 400Mhz scope. I have a signal on Q6 base,
but nothing on the collector. The DC voltage (in TX) at Q6 is 12.0
Collector, 1.8VDC base and 0 on emitter. I don't see anything wrong DC
wise, is it likley that Q6 is bad? What else should I look for? With
the radio off the R at Q6 emitter to ground is 1.8ohms, that looks
normal, so I don't have any current flow in Q6, it looks like.
Thanks,
Gordon - N1MGO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
