Hi Alan,
I would strongly recommend that you do NOT use ALC for any form of
control signal or drive limiting. For control use the inhibit on the
acc connector and for power output use the K3 pwr control.
Look forward to hearing you on 2m.
73
Peter
G3SMT
On 04/03/2018 21:04, G4GNX wrote:
I'm about to build a linear amplifier for 2 meters and the design I've
chosen sends a negative voltage to the driving rig's ALC line to
inhibit RF input, whilst the linear goes through a TX sequence.
In view of the way that ALC is used differently with the K3S and
KPA500, does the use of ALC in this way seem feasible for use with the
K144XV transverter?
Has anybody done this?
73,
Alan. G4GNX
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
