My K3 is also from 2010, April as I recall. I recently did the component mods you mentioned except for the KREF3 and KPOD resistors. Also I added the general coverage BPF board with 472 kHz in mind. I added the new synthesizer as soon as it came out. It all went very well and only took a few hours, stretching it out to prolong the fun of getting my fingers into my factory built K3. :-)
Add to your list the suggested thermal pads under the LPA transistors. These are recommended if you do a lot of 100% duty cycle transmitting. Good luck & 73, Brian, K0DTJ > On Mar 23, 2018, at 06:53, ke9uw <[email protected]> wrote: > > My K3 was purchased in 2010 which seems to avoid most of the early required > mods. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
