Bill, Thanks for your response. I tried tuning into a 50 ohm dummy load (using known good cables), and see the same issue.
Neither the BNC nor the internal cables look damaged in any way. I'll note I never use an internal battery, so I rarely open the unit. -- Chris (KD2FLH) On March 25, 2018 10:18:15 AM EDT, Nr4c <[email protected]> wrote: >Check every connection in any system. VSWR of 25.1 is normal for an “no >antenna” condition at any connector. Something is disconnected. > >WIt’s this HI SWR you will get HI CUR warming as radio tries to develop >power into the non-existing antenna. And you will not get much power >developed. > >Sent from my iPhone >...nr4c. bill > > >> On Mar 25, 2018, at 9:32 AM, Chris <[email protected]> wrote: >> >> My KX2 started now only reports 25.4-1 when attempting to tune my >antenna. The value does not fluctuate during the tuning process. >> >> During some transmit attempts (SSB, Power set to 3.0W), I received >the "HI CUR"message. In general, my reported power output never gets >above 0.5W, no matter what power settings are used. >> >> Any help would be appreicated. >> >> --Chris (KD2FLH) >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
