Don’t forget that rear Mic is not same as Lin In! Sent from my iPhone ...nr4c. bill
> On Mar 31, 2018, at 8:14 AM, Richard Ferch <[email protected]> wrote: > > I suspect that what you most likely need is for Line In to be used during > digital mode operation (with the microphone muted), and the microphone to > be used during voice mode operation. > > The audio input settings for voice modes and digital modes are stored > independently, so this is easy. With the radio in SSB, you set MIC SEL to > wherever your microphone is plugged in, with the appropriate bias and level > settings. With the radio in DATA A or AFSK A mode, set MIC SEL to LINE IN > and adjust the Mic gain control to get the required 4-5 bars of ALC meter > reading in digital modes. > > The only reason you might need MIC+LIN to be set to ON is if you were using > the computer sound card as a digital voice keyer in voice modes, in which > case you might want both microphone and line in to be active while > operating in voice modes. In this case, set MIC+LIN to ON with the radio in > SSB, and OFF with the radio in DATA A or AFSK A. > > In both cases, you will only need to set this up once; the settings are > remembered independently in the two modes from then on. > > 73, > Rich VE3KI > > W7HSG wrote: > > Does any one know the command for both Mike in Front Panel and Line in rear > panel? > > I need both at the same time, Mike for voice and Line in for digital. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
