Last week there was a thread about this. Leaving the probe in increased some spurs in the transmitter output. Values were not given, but it sounds removing it is the better idea. When you are done tweaking the filters take it out. Rick WD8AJG K2 #5296
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of N2TK, Tony Sent: Tuesday, May 09, 2006 6:39 AM To: Elecraft (E-mail) Subject: [Elecraft] K2 VCO Shield instructions - Freq Counter probe Just installed the K2 VCO Shielding Upgrade. The instructions say to disconnect he frequency probe and completely remove it from the K2. I used to leave it in TP2. Does it really make a difference with anything by leaving it in TP2? Tnx N2TK, Tony #3481 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
