Placing both PS and amp where the 220 VAC outlet is accessible is possible; but then I wouldn't be able to see the amp while operating, which I would like to do. Wouldn't feel comfortable with a 1500 watt amp running way out of sight. It would also then be in the kitchen on a floor above. Not aesthetically the best that way, either.
As I described in reply to one other suggestion: The "shack" is a spare bedroom in the lowest (of three) level of the house, which because it is built into a hillside and therefore half of it is below grade, has 12 inch concrete walls and a six inch (as I remember it) concrete floor covered only with a carpet and carpet pad. The ceiling of that room is finished as is the entire interior. The problem with snaking a line through the walls from the distribution box which is on a deck above ground level is that the entire space between the inside side of the concrete and the drywall is filled with cellular foam insulation. It was, when we had it built, the recommended way to go for the mountain climate. I did think to have a conduit put through the wall to allow antenna feedline coax to go through; but the electrician who was there said there is now no way to get a 220 line through the walls without major destruction. I might bring it overhead (between the finished ceiling of the lower level and the floor of the next level up) but then to get it down to a usable level in the "shack" would require a conduit running down the inside wall surface. That may be what I will have to do . . . Or maybe Tesla's idea could be resurrected -- a big inductor inside and a transmitting power source out in the yard. I believe the Wardenclyffe Tower was originally planned for Colorado Springs, only 40 miles from the operating QTH. Some parts might still be available. Any other ideas from those who know about these sorts of things? Tnx, Ted, KN1CBR On 4/28/18, 8:55 AM, "Dave AD6A" <[email protected]> wrote: Why not just use the amp as-is near the 220V outlet and run longer RF coax cables to the amp from your operating position? Dave AD6A Sent from my iPhone X On Apr 28, 2018, at 6:54 AM, Dauer, Edward <[email protected]> wrote: The KPA1500 Manual states that “the power supply can be operated remotely” and that the supplied cables are 66 inches long. It does not say how far apart, beyond the 66 inches, the PS and the amp can be without affecting performance or creating other issues. Does anyone know? There are apparently three cables – the main HV, the 15-pin control, and the 12VDC phono plug cable for remote turn-on of the amp. Thoughts, anyone? Thanks, as always, Ted, KN1CBR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
