Mark,
Are you using the USB cable to connect the K3S to the computer? If so,
do you have the CBLP3Y cable connected between the K3S RJ-45 jack and
the P3 RS-232 connectors? If you do have that cable, make certain the
RJ-45 plug is fully inserted. You may have to pull back the cover and
push the metal part of the plug in completely - it must snap in.
If you do not have the CBLP3Y cable, you can use the RJ-45 to RS-232
cable that comes with the K3S to connect to the P3, but you must set the
K3S menu to RS-232 rather than USB (use 38400 baud). Connect to the PC
from the RS-232 connector on the P3.
73,
Don W3FPR
On 5/22/2018 5:35 PM, Mark Wheeler wrote:
I am using the P3 with a K3S and cannot figure out how to get the VFO A
frequency to appear at the top center of the P3. (My P3 is showing a “0” at the
top center.)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
