Don, Problem corrected. The K3S was set to the wrong baud rate.
Thanks! Mark WU6R Sent from my iPad > On May 24, 2018, at 12:57 AM, Don Wilhelm <[email protected]> wrote: > > Mark, > > Using the cabling shown on page 6 of the P3 manual, you must connect the > computer to the P3 with an RS-232 cable or USB to serial adapter (not the K3S > USB cable). > Also set the K3 menu RS-232 parameter to 38400 and NOT USB. > Be certain the P3 is also set to 38400 baud. > > Again, pull the boot on the RJ-45 dongle back and push on the metal part of > the plug to make certain it is fully seated. > > If you switch to the K3S to computer USB cable, you must use the CBLP3Y cable > between the K3S and the P3 as shown on page 5 of the P3 manual. > > 73, > Don W3FPR > >> On 5/23/2018 9:05 PM, Mark Wheeler wrote: >> Don, >> >> I have everything setup as shown on page 6 of the P3 manual. I am using the >> serial cable with the RJ-45 jack. All connections appear tight. I am >> wondering if there are any setting on the K3S that need to be checked or >> set. Both the K3S and P 3 are brand new. The K3S is loaded with all >> available options except the 2 meter band option. >> >> Thanks, >> Mark >> WU6R >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
