Hi all,
at the WinTest-reflector people asked why the K3 does not appear
"smooth" in the band map as another vendor's TRX.
I made some tests and found out the following, see below.
Now my question: will the new USB-Interface change that timing behavior?
tnx, 73, Gernot DF5RF
I just checked, here is my result:
K3 (FW 5.6)
set AutoInfo to 1: K3 sends out IF-msgs while moving the VFO knob,
even
on 10Hz changes.
The K3 rather slows down message output to about one second,
whatever you'll do with the VFO knob. The timing behavior is
identical to Autoinfo=2.
set AutoInfo to 2: K3 sends out FA/FB messages, WT does not react
to them
KX3: (FW 2.9)
same as K3
K2: (FW 2.04)
same as K3, except it only sends messages after the VFO knob stops
with
a delay of about 1-2 seconds.
Gernot, DF5RF
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
