Phil, Anderson Power pole connectors are 'genderless' - meaning that if you assemble them all the same, they will fit together with no polarity problems.
To assemble the red and black housings, I look for the little 'A' stamped on the end (this is often called the tongue) - with the 'A' upright, the black one should be on the left. Note on the sides of the housings there are dovetails - slide the two housings together with the dovetails engaged. You will find other 'sayings' that folks use - something like 'tongues down, hoods up, the black one is on the right' Either way works, so use whatever appeals to you, I just prefer to look at the end and make the 'A's upright, and I know in that orientation the black one goes on the left. 73, Don W3FPR > -----Original Message----- > > I am finishing a XV-50 transverter. Down to making the power > cord. How is > it supposed to plug on to the XV-50?? > > have 2 red and 2 black connectors and 4 crimp pins. I had no problem > mounting the PCB connectors. H ow are they supposed to plug > together since > these are the sane size? I looked on Anderson's web site but, did'nt find > any good info there. > > Phil K8MBY > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
