Hi Don, I understand about the Errata. The confusion is the Errata is for the KXV144 Reference module dated Dec 5 2013 showing placement at J1 on the KSYN3A. The K3EXREF manual is dated August 23, 2016 and shows placement at J4 on the KSYN3A. Hence confusion? Glenn Maclean WA7SPY
> On Jul 14, 2018, at 8:19 AM, Don Wilhelm <[email protected]> wrote: > > Glenn, > > The errata sheets always supersedes the manual - it is the latest > update/correction. The designation on the errata title carries the manual > designation that is to be corrected. > Go to the Documentation download page to be certain you have the latest. > > 73, > Don W3FPR > >> On 7/14/2018 10:41 AM, WA7SPY wrote: >> >> The K3S and options are all working. I had a problem with 2meters being off >> frequency after adding the K3EXREF and the K144XV reference board. I did a >> complete reset to factory defaults. I removed the K144XV reference board. >> Then set the 2 meter offset back to what was labeled on the module. The 2 >> meter frequency was accurate. I put the K144XV reference board back in. Now >> the 2 meter frequency is accurate with the board back in. My question is >> where is the TMP cable suppose to be connected on the KSYN3 board? I have >> one end connected to REF IN on the 2 meter module. I initially connected the >> other end to J4 on the KSYN3. I now have it connected to J1 on the KSYN3 do >> I have the TMP cable connected correctly? The documentation is a little >> confusing to me. Figure 13 page 15 on the K3EXREF manual shows J4 being used >> on the KSYN3A if both the KXV144 reference board and the KEXREF options are >> installed. There is an Errata sheet showing to use J1 on the KSYN3 board. >> Which one is cor >> rect to use for my set up J1 or J4? >> The K3EXREF is working with very accurate frequency on the HF bands with my >> GPS 10 MHz disciplined oscillator clock connected. The 2 meter frequency >> was off when connected to J4. I am not sure if it was corrupt software and >> doing the reset corrected the issue and am uncertain where to connect to on >> the KSYN3A board? ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
