On Tue, Jul 24, 2018 at 8:10 AM, Mike Flowers <[email protected]> wrote:
> 1. Turn off the VOX > 2. Set MODE to DATA, data mode to DATA A > 3. Set LINE IN > 4. Mic (Line) Gain to 3 > 5. Monitor Level to 3 > 6. Then set the P3's center frequency to 18101.50 kHz with a SPAN of 4 > > VX0;MD6;DT0;XF2;MN255;MN053;UP;UP;MG003;ML003;MN255;#CTF+000 > 18101500;#SPN000 > 040;MN255; > > The macro as written performs Steps 1 - 5 on its first execution but will > only perform Step 6 - the P3 commands - on the second execution. > After the first execution, the center frequency on the P3 shows what appears > to be a random frequency, and the correct frequency is only shown on the > second execution of this macro. I think there is some band stack effect > or > something going on but the command set for the P3 is limited. > Is the P3 in FIXED or TRACKING mode? Commands inserted in front of your macro, below: 1. Set frequency of VFO A to 18101.50 2. Change P3 to FIXED mode 3. Enable half-span scrolling FA00018101500;#FXT1;#FXA1;VX0;MD6;DT0;XF2;MN255;MN053;UP;UP; MG003;ML003;MN255;#CTF+00018101500;#SPN000040;MN255; Tested this using the K3 Utility, and it seemed to work OK. 73, Bob, N6TV ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
