I seem to be suffering a recurrence of a very old problem (years ago) for which I don't recall the solution:
I have a real K3 at the control site, controlling a K3 at the remote site via RRC-1258 MkII boxes. I have a mechanical D-SUB 9 pin switch to route the control site K3 serial port to either a local computer or the RRC. When routed to the RRC and operating normally, when I turn on the K3 it begins to show its power-on banner in the VFO B area, then mid-way through that scroll detects that it's in TERM mode with an RRC connected, powers up the remote K3, and all is well. However, that doesn't seem to be working now. The control K3 comes up and fails to detect the RRC. The power-on banner for the control K3 completes its scroll and the radio operates locally. I think it is slipping out of TERM mode. I can force it back into TERM mode with a long hold of the CONFIG button, but then it never turns on the remote radio. If I turn off the control K3 and then back on, it apparently has forgotten it was in TERM mode. Any advice? Thanks, /Rick N6XI -- Rick Tavan Truckee, CA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
