Thanks Don, So with my basic K2, I should get agreement between the K2's setting and its output when driving my 50 ohm dummy load. I'll check it that way and report back.
I never completed the RF probe with the K2 (didn't need it). I assume it simply converts RF AC voltage into DC voltage (probably RMS) so you can measure it with a DVM, right? So at 10 watts into a dummy load, I should see 22.4 volts? Does the diode drop some voltage so I'll actually see 21.7? There is so much I don't know about this stuff since rig since it went together with no problems and worked fine the first time. It didn't give much opportunity to do any trouble shooting. Gee Darn :-) - Keith KD1E - -----Original Message----- From: Don Wilhelm [mailto:[EMAIL PROTECTED] The basic K2 power ouput indication is very accurate when operating into a 50 ohm non-reactive load. If it is driving anything other than that load, the indication will be inaccurate - the basic K2 does not have a wattmeter, it does have an RF Probe type detector which reports the RF Voltage to the microprocessor and the 'power' is computed based on the assumption that the load is 50 ohms. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
