Hi all, Several years back there were discussions about how to limit KX3 transmit capability to the regional ham bands applicable to a KX3 user. As a USA user, I wanted to revisit this topic to see if my recent firmware (v. 2.76) allows enforcement of these limits. On page 42 of the KX3 manual, there is a reference to the BND END message that is supposed to appear if I transmit out of the ham band in my radio, however it puts out full power in CW mode (using a dummy load) at 2.5 MHz for example with no displayed message. I can use the TX Inhibit control line (via the ACC2 connector) to prevent TX, but would also like software enforcement.
Could someone please clarify whether ham band TX enforcement is available for my KX3? Oliver Barrett KB6BA -- Sent from: http://elecraft.365791.n2.nabble.com/ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
